Motorized Test Stands

MH2-110 High Performance Horizontal Motorized Test Stand


MH2 Horizontal Motorized Test Stands used maintenance-free, brushless, DC motors that provide a smooth and powerful operation to ensure consistent force testing results.

Precise Increment Mode
MH2-110 features unique jog movement control, for precise increment testing. In jog mode, each click of the program dial moves the crosshead approx. 0.01mm (standard speed, under no load).

Cycle Mode
In cycle mode, automated fatigue tests are easy to setup. Press the unique program dial and turn, to make selections from the menu screens and set mode, speed, test duration, units, and cycles. Set start and return speeds independently.

Force Control
Force controlled non-destructive tests are also easy to set up and program. Connect a Z Series force gauge to the MH2 test stand to enable the following force-controlled tests and Conditional Overload Prevention.

Maintain Force Between High/Low Setpoints
Initial cross head speed is controlled by the start speed setting. Force control activates when the applied force exceeds the low setpoint (and below the high setpoint) on the Z Series force gauge. The crosshead maintains that force for the programmed interval and then uses return speed to reset for the next cycle.

For more details, please contact us for Pricing and Availability..!!

Features

  • Selectable Manual, Increment, Single Cycle, Continuous Cycle and Force Control (with Z Series gauges).
  • Ultra rigid, .5 mm deflection at maximum load.
  • Conditional Overload Prevention.
  • Stroke: 9" (230mm).
  • Easy-to-use program dial and menu screens control mode, speed, timer, cycles.
  • Programmable timer up to 99' 59.9 sec in 0.1 sec increments.
  • Up to 65,535 cycles.

Related Products

Perform quick and accurate 90-degree peel tests with our test fixtures. Models Available GT-30-1-LF - For testing from 0-44 lbf GT-30-1 - For t ...
GT-30-1 90 Degree Peel Test Fixture
Click image for more info
P45-50N 45 Degree Peel Tester can measure the peak value of the beginning of the opening cover. Peeling strength of a film cover of the plastic con ...
P45-50N 45 Degree Peel Tester
Click image for more info
The G1109 peel test fixture is designed for peel testing of tapes, films, foil seals, and other materials. A large, flat working table moves horizonta ...
G1109 90° Peel Test Fixture
Click image for more info
The ESM303-003 safety shield attaches to an ESM303 test stand, providing pinch and sample debris protection for the operator. The shield is construct ...
ESM303-003 Safety Shield For ESM303 Test Stand
Click image for more info